Protech Tech10 Electric Manuel de l'opérateur télécharger pdf (Page 22)

22 23

Fig. Z

Bevel/Miter Settings

Fig. AA

Settings for standard crown molding lying ﬂat on

compound miter saw table

Miter Saw Table

Outside Corner

Inside Corner

In order to accurately cut crown molding for

a 90° inside or outside corner, lay the molding

with its broad back surface ﬂat on the saw table.

When setting the bevel and miter angles for

compound miters, remember that the settings are

interdependent; changing one changes the other,

as well.

NOTE: The chart below references a

compound cut for crown molding ONLY

WHEN THE ANGLE BETWEEN THE WALLS

EQUALS EXACTLY 90°.

KEY

BEVEL

SETTING

MITER

SETTING

TYPE OF CUT

Inside corner-Left side

IL 33.9° 31.6° Right 1. Position top of molding against

fence.

2. Miter table set at RIGHT 31.6°.

3. LEFT side is ﬁnished piece.

Inside corner-Right side

IR 33.9° 31.6° Left 1. Position bottom of molding

against fence.

2. Miter table set at LEFT 31.6°.

3. LEFT side is ﬁnished piece.

Outside corner-Left side

OL 33.9° 31.6° Left 1. Position bottom of molding

against fence.

2. Miter table set at LEFT 31.6°.

3. RIGHT side is ﬁnished piece.

Outside corner-Right side

OR 33.9° 31.6° Right 1. Position top of molding against

fence.

2. Miter table set at RIGHT 31.6°.

3. RIGHT side is ﬁnished piece.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29

Commentaires sur ces manuels

Pas de commentaire

Protech Tech10 Electric Manuel de l'opérateur Page 22

Commentaires sur ces manuels