Protech Zoom 400 Instructions d'exploitation télécharger pdf (Page 30)

Attaching the Viewfinder

Chapter 2 Preparations

CAUTION

When the viewfinder is attached, do not leave the

camcorder with the eyepiece facing the sun. Direct

sunlight can enter through the eyepiece, be focused in the

viewfinder and cause fire.

Note

When attaching the viewfinder, make notes of the

following points.

• Be sure to power off the camcorder before coupling the

viewfinder connector to the camcorder’s VF connector

(26-pin). If you make this connection when the

camcorder power is on, the viewfinder may not

function properly.

• Couple the viewfinder connector firmly to the

camcorder’s VF connector (26-pin). If the coupling is

loose, noise may appear on the video or the tally

indicator may not operate properly.

1 1 Loosen the viewfinder left-to-right

positioning ring, 2 attach the

viewfinder to the viewfinder fitting

shoe, and 3 tighten the viewfinder left-

to-right positioning ring.

2 Couple the viewfinder connector to the

VF connector (26-pin).

Detaching the viewfinder

You can detach the viewfinder by following the

attaching procedure in reverse order, but there is

an additional action to take: when detaching the

viewfinder from the fitting shoe, pull up the

stopper (see page 30).

To adjust the viewfinder left-to-right position,

loosen the left-to-right positioning ring, and to

adjust the front-to-back position, loosen the front-

to-back positioning knob.

Attaching the Viewfinder

Attaching the Supplied Viewfinder

Stopper

Viewfinder left-to-

right positioning

ring

Adjusting the Viewfinder Position

VF connector (26-pin)

Viewfinder front-to-back positioning knob

Viewfinder left-to-right positioning ring

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 194 195

Commentaires sur ces manuels

Pas de commentaire

Protech Zoom 400 Instructions d'exploitation Page 30

Commentaires sur ces manuels