Protech Zoom 400 Instructions d'exploitation télécharger pdf (Page 48)

Setting the Electronic Shutter

Chapter 3 Adjustments and Settings

To set no color temperature

Select “-----” with “

Electrical CC<C>” or

“

Electrical CC<D>” selected.

When the assignable switch is pressed, the

setting for that position is not displayed. For

example, if “-----” is set for one position, then

switching between the remaining three

positions is carried out.

3 Repeat step 2 as required.

4 Assign the electrical CC filter switching

function (ELECTRICAL CC) to an

assignable switch (see page 151).

White balance memory

Values stored in memory are held until the white

balance is next adjusted even when the camcorder

power is turned off.

The camcorder has two white balance memories,

A and B. You can automatically save adjustment

values for each ND filter in the memory that

corresponds to the WHITE BAL switch setting

(A or B). The camcorder has four built-in ND

filters, allowing you to save a total of eight

adjustment values (4 × 2). However, the contents

of the memories are not linked to ND filter

settings in the following cases.

• When the number of memories allocated to

each of A and B is limited to one by setting

“OPERATION” > “White Setting” > “Filter

White Memory” in the setup menu to “Off.”

• When the electrical CC filter switching function

has been assigned to an assignable switch, or

when a remote control unit has been connected.

(In these cases, the contents of white balance

memory are linked to electrical CC filter

positions (A to D).)

Also, when “OPERATION” > “White Setting” >

“White Switch<B>” in the setup menu is set to

“ATW (Auto Tracing White Balance),” and the

WHITE BAL switch is set to B, the ATW

function is activated to automatically adjust the

white balance of the picture being shot for

varying lighting conditions.

Note

While the ATW function is activated, the color

temperature of the subject may differ from the color

temperature that is displayed on the viewfinder screen.

Standard mode

Select this mode for shooting fast-moving

subjects with little blurring.

You can set the shutter speed in one of two shutter

modes: Speed mode, in which the speed is set in

seconds, and Angle mode, in which the speed is

set in degrees.

Speed mode

a) This speed cannot be selected when the camcorder is

in Slow & Quick Motion mode and “OPERATION” >

“Rec Function” > “Frame Rate” in the setup menu is

set to a value that is greater than the system frequency.

Angle mode

180°, 90°, 45°, 22.5°, and 11.25°

ECS (Extended Clear Scan) mode

Select this mode for obtaining images with no

horizontal bands of noise when shooting subjects

such as monitor screens.

As shown in the following tables, the range of

shutter speeds that can be set varies depending on

whether the Slow & Quick Motion (S&Q)

function is on or off.

Setting the Electronic

Shutter

Shutter Modes

System

frequency

Shutter speed (unit: seconds)

59.94i

59.94P

50i

50P

60,

100,

120

125

250

500

1000

2000

29.97P

100,

120

125

250

500

1000

2000

25P

60,

100

120,

125

250

500

1000

2000

23.98P

100

120,

125

250

500

1000

2000

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 194 195

Commentaires sur ces manuels

Pas de commentaire

Protech Zoom 400 Instructions d'exploitation Page 48

Commentaires sur ces manuels